Downloads
- Columns
- Corbels
- Finials
- Flat Stock
- Shutters
- Tile Vents
- Tri Brackets
- Truss Tail
- Window Trim
- Windows Cross Header
AAP Product Installation
When installing Arizona Architectural Products take special effort to seal any wall penetrations. When installing product or blocking on the exterior, install all screws at an upward angle of 15 degrees toward the structure to promote water drainage down and away from the structure use mechanical fasteners in addition to an approved polyurethane adhesive such as PL polyurethane Premium Construction adhesive ( available at Home Depot or Lowes ). The adhesive should be applied along the entire edge that contacts the wall surface. Place screws at 12"-16" inches on center over the length of the piece (for large items), on each side of all joints and/or within 2-4" inches of the edge or corner. Apply adhesive/sealant to screw pints to prevent water penetration.
For Columns adhere joints with two-part epoxy (3M #2216 or equal), following that product's application instructions. This is required on all column joints as well. Primer and sealer should be removed where the adhesive/sealant will be applied.
For holes larger than a pencil bondo should be applied to screw pints and joints, sanded for small areas exterior spackling may be used
Always use mechanical fasteners, never just use adhesive alone-to install AAP products.
After Drywall-Non-structural Interior
- Locate solid backing above and below column.
- Mark floor and ceiling for backing location.
- Cut column to correct height and place in position.
- Using 4"-5"-6" screws (coated coarse thread screws) anchor the cap and base to the backing running the screws vertically through the sides or corners.
- Sink the heads about ¼"
- Sand screw holes
- Fill with a lightweight automotive bondo
- Then sand smooth - note: paint will not adhere to un-sanded bondo.
Limitation of Warranty
Except as set forth in this warranty, Arizona Architectural Products makes no warranty expressed or implied as to the merchantability or fitness for any particular purpose of the products. Arizona Architectural Products will in no event be liable for consequential or incidental damages arising out of any breach of any express or implied warranty. Arizona Architectural Products liability will not exceed the original purchase price of the shutter excluding installation, freight and taxes. Some states do not allow limitations on implied warranties or the exclusion or limitation of consiquential or incidental damages, so the above limitations and exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.